I have a T dolly set that I had made and thought I could add it to the stake dolly stand. I cut the sides of all of them to have the same taper as the stake dolly head. Clamping it to the side the stand I added a off cut to each side.

Added a front face to it as well and then welded it all together. Made another piece too from the offcut of the towbar tongue. The flat narrow top is handy inside of channels etc.

Came up with with this idea to turn into dollies. These are black pipe bends used in steam pipe installs etc. Bought them all for around $40 AUD from an industrial supply place as was much cheaper than a plumbers supply. Welded them to more 8mm-5/16" flat that I cut out of my old 8" channel bumper that was on my Willys Truck when I bought it!

I welded them on their side so I could use both the convex and concave sides for forming. If they need more mass I can fill them with resin or similar.

I decided to make a rack to hold all the T dollies. Also added a couple of holders for the mallets I use the most on there. Even gave it a paint job! I wont add anymore racks or attachments to it as can then start limiting want I can hang over it without things getting in the way.

[INDEX]